• Rookie
Módulo ZVS Sem bobina de aquecimento sem fã de resfriamento Placa de aquecimento Power: 120W para indução de aquecimento

Módulo ZVS Sem bobina de aquecimento sem fã de resfriamento Placa de aquecimento Power: 120W para indução de aquecimento

Rating 
€ 12.90

Montante
In stock

A placa final do Mini ZVS não possui torneiras, bobina de aquecimento, bobina de ignição, ventilador de resfriamento, etc A potência máxima é de 120 W (aquecimento de indução de 12 V). Empurre a bobina de ignição para 12 V, quando os 5 + 5 voltas primários, são cerca de 30 W. Mini Versão ZVS Sem Tap Pedido de Indução de Produto acabado O aquecimento para a direção da escada sem fã de resfriamento. Esta placa de aquecimento requer uma certa quantidade de capacidade prática e conhecimento relacionado. A placa final do Mini ZVS não possui torneiras, bobina de aquecimento, bobina de ignição, ventilador de resfriamento, etc. A potência máxima é de 120 W (aquecimento de 12 V de indução) . Empurre a bobina de ignição para 12 V, quando os 5 + 5 voltas primários, são cerca de 30 W. Mini Versão ZVS Sem Tap Pedido de Indução de Produto acabado O aquecimento para a direção da escada sem ventilador de resfriamento. Esta placa de aquecimento requer uma certa quantidade de habilidade prática e conhecimento relacionado. Especificação : Item Tipo : ZVS Module Model de aquecimento de indução : BYS459-1500 Voltagem : 5 V-12 VMAXIMUM POWER : 120 WPACKAGE LISTA : 1 x ZVS Módulo de aquecimento de indução 1 x para a bobina NOTA : : 1.

Mais dados

Item Type:
ZVS Induction Heating Module
Model:
BYS459-1500
Voltage:
5V-12V
Maximum Power:
120W
Package List:
 1 x ZVS Induction Heating Module :
 1 x For Coil :
Note:
1. Mini version ZVS no tap finished product induction heating for Tesla stepladder drive without cooling fan:
2. This heating plate requires a certain amount of hands-on ability and related knowledge.:
3. The maximum power of 120W (12V induction heating). Push the high voltage package 12V, when the primary 10 turns, about 30W.:
4. The input voltage DC 5V ~ 12V, this voltage range is the voltage at work, not the voltage when the power supply is empty!:
5. Confirm that all components are soldered correctly, the positive and negative poles of the power cord are not reversed, after the load is connected (heating coil, high voltage package), and then power on! No load can be powered! No-load power is easily damaged!:
6PCS heating coil:
The width of the heated object should be between 1/3 and 1/2 of the inner diameter of the heating coil, and the maximum should not exceed 2/3!:
The diameter of the heated object should be controlled within 20mm as much as possible. If the heating is too large, it will be difficult to heat up to red. After all, the power is limited.:
Inductive heating, usually work for 5 minutes to power off cooling. Because the current is relatively large during induction heating, the coil he:

Mais produtos na categoria